Formula 1 TH500 Bedienungsanleitung Seite 15

EN
5� Do not overtighten the screw to prevent
squashing the tube in its diameter�
The connecting tube is now fully assembled�
Assemble all modules
A single screw connection is used to assemble all
preassembled modules� Proceed as follows:
1� Pick up the preassembled frame (Fig. F)�
Lay the frame (7) on a stable surface so that
you can easily access the front wheel; the
wheel may not rest on the surface�
2� Insert the threaded pins on the frame through
the holes on the rear axle with brake (8) and
through the holes on the connecting tube (18)�
3� Place one washer (thick, 20 mm) (15) each on
the threaded pins and tighten them with nuts
(ø 9 mm / M8) (14)�
Make sure the brake (22) is on the correct side
(see Fig. F and G)�
4� Place one spacer bushing (13) each between
the connecting holes on both sides of the
modules (above and below, see Fig. G)�
5� Insert one screw (ø 9 mm) (12) each through
the spacer bushings and secure the modules
with washers and nuts�
6� Make sure that the wheel tree is secure and
stable�
All components are now assembled and the
wheel tree is fully assembled�
Fig. G
20
f1.mts-gruppe.com
Use of the
wheel tree
Prepare the wheel tree for loading
Before loading the wheel tree with rims or rims
with tires, always check the product�
•
Make sure that all parts of the wheel tree are
assembled and fastened�
•
In particular, make sure that the stopper (21) is
correctly assembled� It prevents the wheel tree
from tipping over when loaded�
Mount the handle to aid in maneuvering the
loaded wheel tree� Proceed as follows�
1� Pick up the handle (16) and attach it to the
connecting tube (18) that sticks up from the
connecting tube module�
2� Screw the clamp screw (17) into the con-
necting tube (hand lever) and turn the screw
connection until the handle sits securely on the
connecting tube (hand lever)�
You can now maneuver the wheel tree� Use the
handle to do so�
In order to use the wheel tree to store rims and
rims with tires, additional assembly steps are
necessary�
1� Insert the lower tube (without plug) (3) into
the locating hole on the frame (7) and fasten
it with a screw (ø 9 mm) (9) and nut (10 mm)
(10)�
2� Insert a locking pin (4) into the lowest pair of
holes on the lower tube (without plug)�
3� Attach a rest (2) to the lower tube (without
plug)�
Make sure that the lower flange of the rest
clicks into the two grooves on the locking pin�
This prevents the locking pin from falling out
of the pair of holes on the lower tube (without
plug)�
The wheel tree is now prepared for loading with
rims / rims with tires�