Before Assembly - Formula 1 TH500 Bedienungsanleitung

surface only� Do not place the wheel tree at the
side or edge of the surface�
•
Never expose the wheel tree to high tempera-
tures (heaters, etc�) or weather effects (rain,
etc�)�
•
Never immerse the wheel tree in water and do
not use a steam cleaner to clean the product�
Otherwise, the wheel tree may be damaged�
Before assem-
bly
Check the wheel tree and delivery
contents
Please note!
Risk of damage!
Carelessly opening the packaging with a sharp
knife or other pointy objects can easily result in
damage to the wheel tree�
•
Open the packaging carefully�
1� Remove the wheel tree from the packaging�
2� Check whether the delivery is complete (see
Fig. A–F)�
3� Check the wheel tree and the individual parts
for any signs of damage� In case of damaged
parts, do not use the wheel tree� Contact the
manufacturer under the service address listed
in the instruction manual�
Assembly
The wheels (11) on the frame (7) and on the rear
axle with brake (8) are preassembled on delivery�
The following assembly instructions describe
how to remove and reassemble the wheels and
how to replace damaged parts with original
replacement parts�
Two open-end wrenches (not included) are
required to assemble the wheel tree�
Assemble the frame
To ease assembly of the front wheel,
it is recommended to secure the
frame, e�g� by clamping the frame to
a tabletop (table tennis table)� You
can use a screw clamp to do this (not
included)�
1� Lay the frame (7) with the socket for the lower
tube (without plug) (3) on a stable surface so
you can easily access the fork near the front
end�
2� Place the wheel (11) centered between both
branches of the frame�
3� Slide the wheel between the frame and fasten
it with the front axle (5), two washers (thin,
20 mm) (6), and a nut (ø 9 mm) (14) (see
Fig. B)�
The frame is now fully assembled�
Assemble the rear axle
To ease assembly of rear axle with
brake, it is recommended to secure it,
e�g� by clamping it to a tabletop (table
tennis table)� You can use a screw
clamp to do this (not included)�
1� Lay the rear axle with brake (8) flat on a work-
ing surface� Make sure you can easily access
both ends of the rear axle with brake�
2� Attach a wheel (11) to the journal on the rear
axle with brake (see Fig. C)
3� Fasten the wheel with one washer (thick,
20 mm) (15) and a nut (ø 9 mm) (14)�
4� Repeat steps 2 and 3 on the other end of the
rear axle with brake�
The rear axle with brake is now fully assembled�
Assemble the connecting tube
1� Pick up the connecting tube (18)�
2� Hold the stopper (21) against the mounting
hole from below (see Fig. E)�
3� Screw the screw (7 mm) (19) with the washer
(17 mm) (20) into the stopper from above�
4� Make sure that the stopper lies fully flat
against the bend in the tube�
EN
19
English