Hama Full Touch Bedienungsanleitung Seite 6

Note
• The range of the radio transmission between the measuring
station and the base station is up to 30 m in unobstructed
areas.
• Before installing, make sure that the radio transmission is
not in uenced by interfering signals or obstacles such as
buildings, trees, vehicles, high-voltage power lines, etc.
• Before nal installation, make sure that there is su cient
reception between the desired installation locations.
• When installing the measuring station, take care to ensure
this is positioned so that it is protected from direct sunlight
and rain.
• The international standard height for measuring air
temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a specialist
dealer for wall-mounting.
• Ensure that you do not install any faulty or damaged parts.
• Never apply force during assembly. These can damage the
product.
• Before mounting, check that the wall you have chosen is
suitable for the weight to be mounted. Also make sure
that there are no electric, water, gas or other lines running
through the wall at the mounting site.
• Do not mount the product above locations where persons
might sit or stand.
5.1 Base station
• Place the base station on a at surface using the stand (24).
• Alternatively, you can mount the base station on a wall using
the recess (23) on the back.
5.2 Measuring station
• You can also set up the measuring station on an even surface
outdoors.
• We recommend mounting the measuring station securely and
rmly onto an outdoor wall.
• Secure the dowel, screw, nail, etc. in the wall provided.
• Hang the measuring station onto it using the cut-out (27)
provided.
5 5
6. Operation
6.1 Connection to the measuring station
• After the batteries are inserted, the base station automatically
searches for a connection to the measuring station and carries
out the initial setup routine.
Note
• Initial setup takes around 3 minutes.
• The radio symbol Measuring station (26) ashes when
searching for a connection.
• Avoid any operation of the buttons during this time!
Otherwise, errors and inaccuracies may occur in the values
and their transmission.
• The process is nished as soon as the indoor (8) and outdoor
(2) measurement data are displayed.
• The measured value is automatically updated by the base
device about every 58 seconds.
• If the temperature value is outside of the measuring range,
LL.L for temperatures below the measuring range or HH.H for
temperatures above the measuring range will be displayed in
the temperature indicator.
• If no signal is received from the measuring station on a
repeated basis, press and hold the
around 3 seconds to start the manual search for the signal.
Note - faulty transmission of the measured
values
• In some cases, interference caused by a WiFi network,
computer, TV, etc., for example, may cause the transmission
of measured values between the base and measuring
station to fail.
• If this happens, resynchronise the stations by brie y removing
the batteries from both stations and reinserting them.
• If the measured values are not transmitted again, replace the
batteries with new ones.
• If necessary, choose a new location for the base station to
avoid the possible interference signals in the future.
• The measuring station and base station may be placed max.
30 m apart from each other.
• Stay at least 1 m away from interference
6.2 Automatic setting according to the DCF signal
• After successful transmission of the indoor and outdoor
temperatures between the measuring and base stations, the
weather station (after around 3 minutes) automatically starts
searching for a DCF signal. The DCF radio symbol (15) ashes
during the search process.
• When the radio signal is received, the date and time are set
automatically. This can take a further 10 minutes.
button (B) for