Herunterladen Inhalt Inhalt Diese Seite drucken

Pairing With The Subwoofer; Manual Pairing - Renkforce 2366444 Bedienungsanleitung

2.1 dolby atmos soundbar mit funk-subwoofer
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

• Subwoofer
Connect the mains cable to the AC~ socket on the subwoofer, and then to a mains socket.
d) Pairing with the subwoofer
1) Automatic pairing
The subwoofer and soundbar will automatically pair when both units are plugged into the mains sockets and turned
on. No cable is needed for connecting the two units.
• Determine the status based on the wireless subwoofer indicator.
LED
Fast blink
Constant
Slow blink
NOTE:
- Do not press the PAIR button on the rear of the subwoofer, except for manual pairing.
- If automatic pairing fails, pair the subwoofer with the main unit manually.

2) Manual pairing

1. Ensure that all the cables are properly connected, and the main unit is in Standby mode.
2. Press and hold the PAIR button on the rear of the subwoofer for a few seconds. The subwoofer will enter pairing
mode and the Pair Indicator will blink quickly.
3. Press the
button on the main unit or remote control to switch the main unit on.
4. After the wireless connection has been established, the pair indicator will light up.
5. If the pair indicator blinks, this indicates that the wireless connection failed. Unplug the cable of the subwoofer and
then reconnect the main cable after 4 minutes. Repeat steps 1 to 4.
NOTE:
• If the wireless connection fails again, check if there is a conflict or strong interference (for example, interference
from a nearby electronic device). Remove these conflicts or strong interferences and repeat the above procedures.
• The subwoofer should be within 6 m (19.7 feet) of the soundbar with no obstacles.
• If a TV or external device is connected, the AUX and subwoofer will only switch on automatically when the TV or
external device is switched on.
• If the main unit is not connected with the subwoofer and it is in On mode, the POWER Indicator will flash. Follow
steps 1 to 4 above to pair the subwoofer with the main unit.
38
Status
Subwoofer in pairing mode
Connected/pairing successful
Connection/pairing failed

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis