TFA 30.3016.54.IT Bedienungsanleitung Seite 49

3. After inserting the batteries, the temperature station will start receiving data from the
transmitter. The outdoor temperature and the signal reception icon should then be
displayed on the temperature station. If this does not happen after 3 minutes, the
batteries will need to be removed from both units and reset from step 1.
4. In order to ensure sufficient 868 MHz transmission however, this should under good
conditions be a distance no more than 100 meters between the final position of the
temperature station and the transmitter (see notes on "Mounting" and "868 MHz
Reception").
5. Once the remote temperature has been received and displayed on the temperature
station, the DCF time (radio controlled time) code reception is automatically started. This
takes typically between 3-5 minutes in good conditions. If after 10 minutes, the DCF time
has not been received, press the SET button to manually enter a time initially.
48