Set Up Main Unit; Weather Information Display; Regional Weather Information - Oregon Scientific WMH601 Bedienungsanleitung

The remote sensor reception icon will show the
following status:
ICON
NOTE The main unit will search only for already registered
sensor or new sensor reset within last 30 minutes. To
register a new sensor, reset sensor prior to search.
TIP The transmission range may vary depending on
many factors. You may need to experiment with various
locations to get the best results.

SET UP MAIN UNIT

NOTE Set up the remote sensor before installing the
main unit.
1. Remove the battery compartment cover.
2. Insert the batteries, matching the polarities.
3. Press RESET after each battery change.
DESCRIPTION
Main unit is
searching for
sensor(s).
A channel has
been found.
The sensor
cannot be found.
5
NOTE Batteries should not be exposed to excessive
heat such as sunshine or fire.

WEATHER INFORMATION DISPLAY

REGIONAL WEATHER INFORMATION

NOTE Due to timing of the transmission of weather data,
it may take up to 24 hours to get a valid signal.
Initial synchronisation with Meteo Time can take from 2 to
12 hours. If the weather forecast icons do not appear after
a long period of time, please reset the product and place
it next to a window or a place with less signal interference.
This unit displays the current and next 3-day* weather
information of a user-selected regional city.
strong signal reception of weather information.
* 4-day weather information (current and next 3-days) is
not available for all cities. Please refer to 'Geographical
coverage' addendum sheet for a list of cities and the
available forecasts for each city.
ICON LOCATION
Clock / Alarm /
Calendar /
Message area
Today's Weather /
Regional Weather
area
indicates
DESCRIPTION
Some cities' data
are received
Data for the
selected city
received in the
past 48 hours