THGn132n
1
1. LED status indicator
2. Wall mount hole
3. Battery compartment
4. ReSeT hole
5. CHAnneL switch
GeTTInG STARTeD
ReMOTe SenSOR InSTALLATIOn
1. Step applicable only to THGR122N:
Using a Philips screwdriver, open the battery
compartment cover.
Downloaded from
www.Manualslib.com
2
3
manuals search engine
2. Slide channel switch to select channel 1. Ensure
you use a different channel for the other sensors
(2, 3).
3. Insert the batteries, matching the polarities.
4. Press ReSeT after each battery change.
5. Replace the battery compartment cover.
MAIn UnIT InSTALLATIOn
4
5
1. Remove the battery compartment.
2. Insert the batteries, matching the polarities.
3. Press ReSeT after each battery change.
The battery icon
areas:
AReA
Main unit
environment area
Remote sensor
environment area
nOTe
We recommend that you use alkaline batteries with
•
this product for longer usage and lithium batteries in
temperatures below freezing.
Batteries should not be exposed to excessive heat
•
such as sunshine or fire.
4
may appear in the following
MeAnInG
Main unit batteries low
Remote sensor batteries
low