Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting and Connection Instructions TouchCenter Keypad TFT BUS-2
7.2 Installation hints
The BUS-2 connection lead must be a shielded lead. The shielding should not be used as 0V
feed lines.
"Conductor length"
The installation site of the power supply should be as close as possible to the operating unit.
The following table contains the maximum conductor length:
Distance between power supply and operating unit:
line cross-section of Ø 0.6 mm = 0.28 mm
Cross-section
2
(mm )
0,28
0,56
0,84
1,12
1,4
2,52
Cable recommendation: JY(St) nx2x0.8Ø
In order to obtain optimum interference immunity, the connections should be as follows:
1.
Insulate lines, separate tracer wires.
2.
Shorten incoming and outgoing BUS lines, in so far as they exist and insert in the
terminals
3.
Use cable ties to fix the cables at the pull reliefs on the mounting plate.
4.
Shorten tracer wire(s) and solder to the shield terminal (soldering tab).
Keep the tracer wires of the shieldings as short as possible when screwing to the
shield terminal of the housing base (for VdS-kit only).
8. Technical data
Power supply via BUS-2
Rated operating voltage
Operating voltage range
Current consumption at 12 V DC
Operating temperature range
Storage temperature range
Environmental class as per VdS
Protection class as per DIN 40 050
Dimensions (W x H x D)
Dimensions (W x H x D) with VdS-Kit
Screen diagonal
Colour
2
No. of
Max.
cores
distances (m)
1
13
2
23
3
40
4
50
5
65
9
120
line cross-section Ø 0.8 mm = 0.5 mm
Cross-section
2
(mm )
0,5
1,0
1,5
2,0
2,5
4,5
12 V DC
10 V to 15 V DC
96 mA (idle)
150 mA (display brightness low)
190 mA (display brightness middle)
210 mA (display brightness high)
90 mA (LEDs and buzzer, additional to display)
-5 °C to +45 °C
-25 °C to +60 °C
II
IP40
184 x 129 x 34 mm
184 x 129 x 40 mm
5,7" (14,48 cm)
Grey white (similar to RAL 9002)
2
No. of
Max.
cores
distances (m)
1
23
2
47
3
71
4
95
5
118
9
214
17
Werbung
Inhaltsverzeichnis
