Max 10658 Gebrauchsanweisung Seite 45

brush even during ordinary operation. Do not
overstress the wires by applying excessive load
to the brush. The wire bristles can easily penetra-
te light clothing and/or skin.
• Allow brushes to run at operating speed for at
least one minute before using them. During this
time no one is to stand in front or in line with the
brush. Loose bristles or wires will be discharged
during the run-in time.
• Direct the discharge of the spinning wire brush
away from you. Small particles and tiny wire frag-
ments may be discharged at high velocity during
the use of these brushes and may become im-
bedded in your skin.
Additional safety information
• Do not touch grinding and cutting discs until
they have cooled down. The discs can become
very hot while working.
• Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
• This power tool is not suitable for bench-moun-
ted use. It must not be clamped into a vice or
fastened to a workbench, for example.
Fitting tools
Press spindle lock (3), turn axle until it locks.
Undo the collar (1). If neccessary use the
spanner.
Insert tool required into bush.
Tighten collar using spanner.
Release the spindle lock. Grinder is now
ready for use in hand.
Remove tools in reverse sequence.
GB
45