Faber Gala opti-myst Installationsanleitung Seite 20

L
2.5.2 Manual control.
The manual control unit of the Gala is located in the drawer. (See Fig. 2 and 3)
Switch "A": - main switch.
Switch "B": - On/off switch.
Press I once to switch the flame effect on.
This is confirmed by one beep.
Although the lights start burning immediately, it will take approx. 30 seconds for the flame
effect to start.
Press to put the fireplace in "stand-by" mode.
This is confirmed by one beep.
Button "C": - Adjusts the intensity of the flame effect.
A turn to the right will increase the flame effect and a turn to the left will decrease the flame
effect.
2.5.3 The operation of the Remote Control.
Ensure that switch "A" (see Fig. 2) is in the "ON" ( I ) position.
Point towards the fireplace for the remote control to work properly.
The remote control has 2 buttons (see Fig. 8).
The functions are as follows:
Press once switch flame effect on.
I
This is confirmed by one beep.
Stand-by
This is confirmed by one beep.
19 < < < <