Jinbei HD-2 Max Anleitung Seite 42

– For photographic lighting purposes only. Not suitable for perma-
nent room lighting.
– Do not film car, bus, bicycle, motorbike or train drivers while driving
this product. The driver may be dazzled and cause an accident.
This also applies to unlisted persons or groups if possible glare
could cause an accident.
– Do not shine directly into the eyes of people or animals as this may
cause damage to the retina, visual disturbances and even blind-
ness.
– Ensure adequate ventilation during operation. Never cover the
ventilation slits of the unit.
– Do not use or store the unit in high temperatures or in closed
rooms exposed to direct sunlight, and do not charge the battery
while doing so. The product should not be used in ambient tem-
peratures above 40°C.
– Note that the flash tube, modelling light and a connected reflector
can become very hot during operation. Do not touch these parts
during or immediately after operation. Allow the unit components
to cool down before replacing the flash tube or reflector.
– Handle glass parts such as the flash tube with care so that the
glass is not broken. Do not touch the flash tube with bare hands,
use clean cotton gloves or a microfibre cloth. Small residues of skin
grease can cause the flash tube to burst.
– Make sure that the flash tilt lever is firmly tightened before using
the unit and connecting accessories to it.
– Mount the flash unit on a tripod with sufficient load-bearing capa-
city and set up the tripod so that it cannot tip over or slip.
– For storage or transport, disconnect the battery from the flash unit.
– Allow the flash to cool down before packing it for transport or
storage.
Safety Instructions
42