Safety Notes; Symbol Description; Installation Instructions; Technical Data - HANSGROHE Logis Classic 71286000 Gebrauchsanleitung, Montageanleitung

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The hot and cold supplies must be of equal pressures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Thermal disinfection:
The product is exclusively designed for drinking water!
Fault
Insufficient water
Mixer stiff
Mixer dripping
Water escaping in area of swivel
spout
4
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 60°C
70°C / 4 min
Cause
- Aerator calcified, dirty
- Shut-off unit damaged
- Shut-off unit damaged
- O-ring defective
Assembly (see page 34)
English

Symbol description

Do not use silicone containing acetic acid!
Dimensions (see page 33)
Flow diagram (see page 33)
Spare parts (see page 37)
Cleaning (see page 36)
Operation (see page 36)
Hansgrohe recommends not to use as drinking water the
first half liter of water drawn in the morning or after a
prolonged period of non-use.
Test certificate (see page 40)
Remedy
- Clean aerator, replace as necessary
- Exchange shut-off unit
- Exchange shut-off unit
- Exchange O-ring