Making Pasta - ECG Forza 5500 Giorno Bedienungsanleitung

M1 Tamper
M2 Meat bowl
M3 Machine with funnel
M4 Screw conveyor
M5 Lock nut
S3 Kebbe attachment
S4 Insert for kebbe attachment
Place the kebbe attachment with the insert (S3, S4) on the M4 screw conveyor. Tighten lock M5 to M3. Note:
Do not tighten the lock nut too hard. Attach the assembled machine to the multifunction head. Proceed in the
same way as described in the "Meat grinder" section.
• Attach the M2 bowl to the M3 machine funnel.
• Plug to the mains. Select 3 – 6 speed.
• Fill the resulting hollow roll of the mixture with ground meat and divide as required.
WARNING: Never use your fingers to push the mixture into the machine.
WARNING: Do not let the appliance running continuously for more than 5 minutes. Allow it to cool for at least
15 minutes before starting again.
Cookies production
M1 Tamper
M2 Bowl
M3 Machine with funnel
M4 Screw conveyor
M5 Lock nut
S1 Cutter sieve board
C1 Confectionery attachment
C2 Cookie cutter
• Place the cutter sieve board S1 and the cookie attachment C1 on the M4 screw conveyor. Tighten lock M5
to M3. Note: Do not tighten the lock nut too hard. Insert the template C2 for cookies. Attach the assembled
machine to the multifunction head. Proceed in the same way as described in the "Meat grinder" section.
• Attach the M2 bowl.
• Connect the robot to the mains. Select 3 – 6 speed.
• Insert the dough, pre-cut into strips, into the funnel of the machine. Use the tamper if required. The
machine will push out the dough in the desired shape. You can change the shape of the cookies by moving
the cutter.
WARNING: Never use your fingers to tamp the dough into the machine.
WARNING: Do not let the appliance running continuously for more than 10 minutes. Allow it to cool for at least
30 minutes before starting again.

Making pasta

M1 Tamper
M2 Bowl
M3 Machine with funnel
M4 Screw conveyor
M5 Lock nut
P1 Pasta shapes
13