Giropes Baxtran OPTIMA PTO Benutzerhandbuch Seite 8

- If the value is not correct when the load is palced on the back part of the forklift, the user must adjust "C +" of the
group C, contrary to the direction of the hands of the clock dor small variations and following the same direction than the
hands of the clock if the variation is larger.
Note: this procedure of adjustment is possible only when the error is small, on the contrary, the user must not use this method.
The user must also check that the load cells are intact and loose, and make sure that the forklifts do not get into contact. It is also
important to bear in mind that when the value is not exact, the user must adjust just the groups C and D of the plate and the groups
A and B of the potentiometer . If the user do not do this, the hand pallet can not be adjusted correctly.
8
USER'S MANUAL ARX EN EN