Prompt Message Of Instrument - Giropes Baxtran OPTIMA PTO Benutzerhandbuch

1. Between two accumulation operations, the scale must have back-to- process, otherwise, accumulation is refused. 2. Accumulation
operation is effective only when display weight≥F2.2 is set. 3. The scale is in dynamic state.
Adjustment, clearing and printing of accumulated value
In normal weighing state, press
then the display shows current total accumulated value [A 9.500] and flickers. To clear accumulated value, press [Pr 20.5], to make
flicker weight be 0. Press
Attention: set whether to be over detailed data or accumulated data in F4.6.
FUNCTION OF COUNTING SCALE F2.1 = 5
Instrument display
[c 128], showing current quantity.
Sampling method
1. Check whether the scale is in , if not, press
2. Place materials counted on the scale.
3. Press long until the display shows [SAMPLE], and then press
quantity counted just now, and press
If F2.6 = 1, the display shows [000000], input sample weight. Press
setting interface.
4. In this function, press
FUNCTION OF ANIMAL SCALE F2.1 = 6
Operation method
In normal weighing state, place the animal on the weighing platform and its weight must be ≥threshold value set in F2.2.
Press , instrument will collect data sampling. After sampling, the average value of sampling data will be locked, showing A X.XXX.
Press to print; press

8. PROMPT MESSAGE OF INSTRUMENT

The instrument has extremely high stability and reliability, thus is not easy to have error in general situation. Once an error occurs,
please make clear the error first and observe whether the instrument still has error after power-on. Do not hurry to repair the scale
body or instrument. Repair the instrument according to error code of the instrument as possible.
Nº Symbol Analysis
1 Unable to reset after startup
[-EEE]
[ EEE]
2 The weighed object is over full range for 9 days
[ ]
3 The weighed object is below 0 for 5
[ ]
4 Out of clearing range
[ ]
[ ]
5 Invalid operation
on operation panel for more than 2 seconds, the display will show [Zero] for a second, and
to print accumulated data. Press
for setting.
for confirmation. The instrument saves sampling data and quits the sampling interface.
to display switch between quantity and weight.
or to quit the interface.
to quit the interface.
. If F2.6 = 0, the display shows [PC5 00]. Input the
, the instrument saves setting data and quits sampling
Remark
1. Determine it is no-load state in startup;
2. Make calibration again.
Reduce weight on weighing platform
DAYS
Press to reset
Check whether the weighing platform has weight.
Remove weight.
USER'S MANUAL OPTIMAPTO EN EN
17