Giropes Baxtran OPTIMA PTO Benutzerhandbuch Seite 18

6 EEPROM checksum and error
[Err 03]
7 The calibration input weight is too small
[Err 05]
8 The weight in calibration is too light
[Err 06]
9 The scale is dynamic in scale
[Err 07]
10 Setting error of date and time
[Err 08]
11 Error of AD initialization
[Err 09]
12 In loading scale, it indicates to loading weight;
[LOAd]
13 It has enters menu setting
[SEtUP]
14 End of point and loading point calibration
[End ]
15 Including current display weight in accumulated
[Add-- ]
value
16 Accumulated weight overflows
[-OUER-]
17 Loading default value
[Ld--- ]
18 Printing
[Print]
18
MANUAL DE USUARIO OPTIMAPTO
Press reprint factory value. Start up again. If the
information occurs again, return to factory for repair.
Please calibrate the scale again if the situation does not
occur;
Attention: this place is provided with all parameters of
instruments of the factory.
Input≥10 % weight of full range
Load≥10% weight of full range
Inspect the scale body
Set according to specification of date and time
If the error occurs after restarting, return it to the fac-
tory for repair
Load weight according to requirements
Pres [print] to continue setting.
Clear accumulated weight in time.
ES ES