Herunterladen Inhalt Inhalt Diese Seite drucken

Initial Operation; Connecting The Supply Line (For Products With Interchargeable Supply Cable); Installation / Mounting - Seto ALDEBARAN CRANEMASTER AC1350 LED Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für ALDEBARAN CRANEMASTER AC1350 LED:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

The LED crane spotlight is supplied ready for connection to alternating current. The LED crane spotlight is only to be
connected to an alternating current – with the voltage according to the rating plate – to a properly installed safety socket.
Please note that your system corresponds to the relevant VDE guidelines. If you have any questions about this, please
contact your energy supplier or your electrician. Of course we are at your disposal if you have any questions.
ATTENTION!
In the case of versions of the LED crane spotlight with other plug-in systems (not Schuko®), the voltage according to
the rating plate must be observed.
Connecting the supply line (for products with interchangeable supply cable)
To connect the supply line to the LED crane spotlight, insert the cable socket of the supply line into the cable plug of the
LED crane spotlight and turn the threaded ring of the cable socket "hand-tight" (approx. 50 cNm) clockwise.
To disconnect the cable, unscrew the threaded ring of the cable socket anti-clockwise and pull the connectors apart.
DANGER! Electric current!
Before connecting or disconnecting the supply line,
make sure that the LED crane spotlight is disconnected
from the power supply.
ATTENTION!
The LED crane spotlight may only be operated with
the original cable. Cables for replacement or repair can
only be obtained from the manufacturer or its service
representative.
WARNING!
• Lay the cables in such a way that there are no tripping hazards and they are protected from mechanical damage
such as tearing off or being run over.
• If necessary, secure the cables with tape or cable ties.
• Make sure the LED crane spotlight is securely set up and fastened before use.
• Also observe the applicable regulations on occupational safety!
Electric connection
Connect the mains plug of the connecting cable to your mains connection socket.
The LED crane spotlight is ready for operation once it has been connected to the mains power supply.
Mounting LED crane spotlight:
By means of a bracket (C), the LED crane spotlight can be mounted directly at the place of use for many applications. The
mounting holes are provided for this purpose.
14

Initial operation

Installation / Mounting

Cable plug
(LED crane spotlight)
Cable socket
(Supply line)

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis