Getting Started - Klarstein 10041143 Bedienungsanleitung

GETTING STARTED

Unpacking the unit
1. Remove all outer and inner packaging material. Make sure that the ice basket
and ice scoop are included. If the scope of delivery is not complete, contact
customer service.
2. Clean the interior of the device only with lukewarm water and a soft cloth.
Remove the ice basket and clean it.
3. Place the unit in a location without direct sunlight and at a safe distance from
heat sources (such as ovens, cookers, heaters, etc.). Place the unit on a level
surface. Ensure that there is a minimum distance of 15 cm from the wall to the
rear and sides of the device.
4. After unpacking the unit, let it stand for at least one hour before plugging it
into the mains socket to allow the refrigerant to settle.
5. The device must be positioned so that the power cord is easily accessible at all
times.
Note: Only fill the water tank of the machine with drinking water.
Connecting the device
• The unit should be properly earthed for your own safety.
• A 220-240 V ~ 50 Hz socket is required for this device.
Cleaning the device
Thorough cleaning is required before using the device for the first time.
1. Remove the ice basket.
2. Clean the interior of the device with detergent, warm water and a soft cloth.
3. Then rinse the inside of the device with clean water. Open the water drainage
cap on the bottom of the device and drain the water.
4. The exterior of the unit should be cleaned regularly with a mild soap solution
and warm water.
5. Dry the inside and outside of the device with a soft cloth.
6. Open the water drainage cap if the appliance is not going to be used for a
long time so that the water can be completely drained from the water tank.
EN
25