hanseatic HAP35060WKC Gebrauchsanleitung Seite 32

Page EN-12 Operation
In total, five different fan speeds can be
set on the appliance using the Mode (10)
and Fan Speed (11) buttons. From lowest
to highest, these are: Sleep/Low/Mid/High/
Turbo.
(12) Timer:
• You can use the timer function to make
the appliance switch itself off after a cer-
tain time. You can choose 1, 4 or 8 hours
(1h, 4h, 8h).
• Press the Timer button (12) repeatedly
until the LED next to the desired time
lights up. If no LED lights up, the Timer
function is not activated.
(13) Reset:
This button switches off the Filter Change Re-
minder LEDs (2) and resets the time to the
next filter change.
• After changing the filter, the correspond-
ing Filter Change Reminder LED (2) will
still be lit. To turn this off and reset the
operating hours counter (time till the next
filter change), hold the Reset button (13)
for at least 5 seconds.
To reset a specific Filter Change Re-
minder LED, proceed as follows:
1. Hold the Reset button (13) for at least
5 seconds.
The LED for Filter 1 flashes, the LED for
Filter 2 lights up permanently.
2. Briefly pressing the Reset button will
make the other LED flash. As only the
flashing LED will be reset, you can
choose which LED you want to reset.
3. When the required LED is flashing, hold
the Reset button (13) for at least 5 sec-
onds again.
This turns off the LED and resets the oper-
ating hours counter.
If a Filter Change Reminder LED (2) is
permanently on, it may interfere with the
light sensor and cause the Sleep mode to no
longer switch on automatically in Auto mode.