EcoFlow 400-W-Solarpanel Benutzerhandbuch Seite 8

Can I use non-EcoFlow branded power stations with the 400W Solar Panel?
Yes, but only certain types. The power station used must be compatible with MC4 standards in order to
work properly. In addition, other brands of power station may not offer the same levels of compatibility as
EcoFlow-branded power stations, may have lower nominal power ratings, and may not offer the same levels
of performance.
Can I connect 400W Solar Panels with another size of solar panels in series?
Yes, but this is not recommended. Even if the voltage of the two panels are identical, the current ratings
are not. This means that when the panels are connected in series, the current will be limited to that of the
lower solar panel which cause the power of 400W solar panel can't be released entirely, resulting in a 1+2<3
scenario. Please purchase panels of the same size if you intend to connect multiple panels in series.
Can I connect 400W Solar Panels in parallel?
Yes, but this is not recommended. Though 400W solar panels can be connected in parallel, due to its high
output current, may exceed the input current limitation of the power station. Parallel connections increase
power output by doubling the current, but connecting the panels in this way would result in a 1+1=1 scenario
because the input current limitation would restrain the total solor input. We do not recommend connecting
the multiple 400W solar panels in parallel, unless you use a power station with high input current limitation.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.