Bluetooth - Mobile Phone - Kenwood KMM-BT508DAB Bedienungsanleitung

Bluetooth®
Pair and connect a Bluetooth device for the first time
Press B SRC to turn on the unit.
1
2 Search and select the name of your receiver ("KMM-BT508DAB"/
"KMR-M508DAB") on the Bluetooth device.
"PAIRING" "PASS XXXXXX"
KNOB" appears on the display.
• For some Bluetooth devices, you may need to enter the Personal
Identification Number (PIN) code immediately after searching.
3
Press the volume knob to start pairing.
"PAIRING OK" appears when pairing is completed.
Once pairing is completed, Bluetooth connection is established
automatically.
• "BT 1" and/or "BT 2" indicator on the display window lights up.
" " indicator lights up to show the strength of the battery and signal of
the connected device.
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered
in the unit even if you reset the unit. To delete the paired device, see
[DEVICE DELETE] on page 19.
• A maximum of two Bluetooth phones and one Bluetooth audio device can
be connected at any time. To connect or disconnect the registered device,
see [PHONE SELECT] or [AUDIO SELECT] in [BT MODE]. (Page 19)
However, while in BT AUDIO source, you can connect to five Bluetooth
audio devices and switch between these five devices. (Page 20, 21)
• Some Bluetooth devices may not automatically connect to the unit after
pairing. Connect the device to the unit manually.
• Refer to the instruction manual of the Bluetooth device for more
information.
16
ENGLISH
"Device name" "PRESS" "VOLUME
Auto Pairing
When you connect iPhone/iPod touch to the USB input terminal, pairing
request (via Bluetooth) is automatically activated if [AUTO PAIRING] is set to
[ON]. (Page 19)
Press the volume knob to pair once you have confirmed the device name.
Bluetooth — Mobile phone
Receive a call
When there is an incoming call:
• [ZONE 2] illuminates in green color and flashes.
• The unit answers the call automatically if [AUTO ANSWER] is set to a selected
time. (Page 17)
During a call:
• [ZONE 1] illuminates according to the settings made for [DISPLAY]
(page 29) and [ZONE 2] illuminates in green color.
• If you turn off the unit or detach the faceplate, Bluetooth is disconnected.