Overheat Protection - Zelmer ZFD1010 Benutzerhandbuch

PL EN
with water on the heat-and ventilation unit.
If water gets inside the heat-and-ventilation unit and
comes into contact with any electrical components, make
sure to dry the appliance thoroughly before plugging it
into electrical outlet.
Do not clean the body of the heat and ventilation unit
with any aggressive detergents, such as emulsion, milk,
paste, etc. as they can remove the graphic symbols such
as: scales, labels, caution signs, etc.
CAUTION Hot surfaces. Surfaces are liable to get
hot during use.
IMPORTANT WARNINGS
The appliance is intended for domestic use only. Industrial or commercial use will void the warranty. The
supplier cannot be held responsible for injury or damage if the appliance has been used for anything
other than its intended use.
Incorrect operation and use can damage the appliance and cause injury to the user. Do not use the
appliance if it has been dropped or damaged in anyway. If the unit has been damaged take the unit for
examination and or repair by an authorized service agent.
Do not immerse or expose the motor assembly, plug or the power cord in water or any other liquid for any
reason. If the supply cord is damaged, it must be replaced by the manufacturer or by someone who is
suitably qualified to avoid a potential hazard.
Do not let the cord hang over the edge of a table or counter. Ensure that the cord is not in a position where
it can be pulled or tripped over accidentally.
Do not allow the cord to touch hot surfaces and do not place the cord near hot gas, electric burners or in a
heated oven. Use of an extension cord with this appliance is not recommended. However, if it is necessary
to use an extension cord, ensure that the extension cord is equal to or greater than the power consumption
of the appliance to avoid overheating of the appliance and extension cord. Do not use any other appliance
on the extension cord. Do not place the extension cord in a position where it can be
pulled on by children or animals or be tripped over.
Always operate the appliance on a smooth, even and stable surface. Do not place the unit on a hot surface.
Always remove the plug of the appliance safely. Do not pull on the appliances cord to remove the appliance
plug from the electrical socket.
Never handle or operate the appliance with wet hands. Do not cover the air holes of the appliance.
B&B TRENDS, S.L. disclaims all liability for damages that may occur to people, animals or objects, for the
non-observance of these warnings.
10
INSTRUCTIONS OF USE
Information on the product and suggestions for its use
Unwind a sufficient length of the cord from the storage compartment of the heat and ventilation unit before
attempting to use the appliance.
Clean all parts of your appliance thoroughly before first use.
Unplug the appliance after use.
Use and operation
Before using the appliance for the first time, disassemble it and wash all parts that come into contact with
the processed food products (see „Cleaning and Maintenance"). Reassemble once dry.
• Place the appliance on hard, dry and level surface near a wall socket.
• Distribute the food on drying trays and place the trays in the extended position on the heat and ventilation
unit 1.
Apply the lid. To extend the trays, rotate them 90 degrees relative to each other so that a large gap is visible
between them.
Distribute food products loosely on trays, making sure not to block the airflow through the trays. Choose the
number of trays according to the amount of food you intend to dry.
Dehydration is achieved by the circulation of hot air through the trays. The drying time depends on the
content of water in products and their fragmentation. For example, when drying apples, it is recommended
to use slices not thicker than 5 mm.
• Insert the plug into a wall outlet. Switch on the appliance by pressing the On/Off button .The appliance will
start operating on power level setting. The indicator light will come on.
Never use the appliance with trays in the folded position!
For even drying result, it is recommended to change the position of sieves from time to time during
operation. Note that drying products with high water content, such as plums, grapes or wet mushrooms
takes much more time.
• To change the power level, press the power adjust button .
The appliance has two power settings. Press the switch to choose between power level I and II.
• Press the on/off switch to switch off the appliance.
• After finishing use of the appliance, pull the plug from the wall socket.

Overheat protection

The dryer is equipped with a thermal protection system:
Circuit breaker – in case of excessive temperature increase, the heating element will disengage
automatically and the fan will remain on. The heating element comes on again once cooled down to normal
service temperature.
Troubleshooting
The fan or the heating element does not work:
Return the appliance to a service centre.
EN
PL
11