Kerbl 81738 Montageanleitung Seite 6

7. Mount the sheet metal fittings
Screws: 3, 10
Place the sheet metal fittings on the left side wall from the outside and place the number 10
screws and number 3 nuts.
Place the sheet metal fittings on the right side wall from the outside and place the number 10
screws and number 3 nuts.
Screw the front wall to the left side wall using
the number 10 screws andnumber 3 nuts.
7. Install the roof struts
Screws: 1
Screw the 2 long and one short wooden strips to the upper side of the cover plate through
the pre-drilled holes using the number 1 screws.
Pay attention to the position of the large recess on the left in the picture.
Ensure that the slats are flush with the edge of the plate.
8. Final construction
Screws: 3, 10, 1
Place the cover plate between the wall elements. Ensure that the cover plate engages in the wall
grooves to the front and rear.
Ensure the cover plate is facing in the correct direction (see recess on the left in the picture).
Place the right side wall with the sheet metal fittings and place the number 10 screws and num-
ber 3 nuts. Tighten the nuts firmly.
Place the number 1 screwsin the pre-drilled holes all around the top edge.
Before screwing in, ensure that the wooden strips are flush with the upper edge of the walls.
Screw the rear wall to the left side wall using
the number 10 screws andnumber 3 nuts.
Place the body on the base plate. Ensure that the nuts are on the base plate in
the inside of all four corners.
Now screw the walls all around to the base plate (number 1 screw!).
1
3
4
5
9. Attach the roof
Screws: 12, 14
Position the two roof panels. Ensure that the sheet with the double bend is on the top, the sheet
with the single bend at the bottom.
Align the sheets so that the embossed corner marking on each side is flush with the corner of the hutch.
Secure the plates with the numb er 14 screws and the number 12 washers.
1
2
2
3
81738=BA_Mobile_Coop_Holz_0622