Kerbl 81738 Montageanleitung Seite 5

3. Screw on the door strips
Screws: 14
Place the right-hand side wall with the inside facing upwards (visible by the small positioning holes
around the door opening) and position the door strips.
Ensure that the two notches (which serve as alignment aids) are at the upper left and lower right.
Secure the strips with the number 14 screws. Ensure that all screws hit the pre-drilled holes in the
side wall.
Place the front wall (with the cut-out for the chicken flap) with the inside facing upwards (visible by
the small positioning holes left of the door opening) and position the door strip as shown.
Important: The milled recess in the door strip must point upwards.
Secure the strip with the number 14 screws. Ensure that all screws hit the pre-drilled holes in the
side wall.
1
3
4. Install the window panes
Screws: 2
Place the left side wall and the door with the
inside facing upwards (the inside is recognisa-
ble by the small positioning holes around the
window openings).
Remove the protective films from the two win-
dow panes (both sides) and place both panes
on the plate.
Secure the panes with the number 2 screws.
5. Preparation and installation of the doors
Screws: 6, 4
Disassemble the door lock as shown by loosening the screw (left) and the nut (centre).
Important: The disc is loosely seated on the plastic handle, don't lose it.
Place the round fitting into the door from the outside.
Ensure that the ledge on the inside is pointing upwards and to the left. Fasten the screw connection
with the large nut.
Place the handle into the round screw connection from the outside. Then mount the hook and screw.
Before tightening the screw, ensure that the hook is correctly seated on the square of the handle.
Mount the large hinges to the door using the number 6 screws and the number 4 nuts.
Place the door into the right side wall and attach the hinges with the number 6 screwsand the
number 4 nuts.
Important: Align the door centrally before tightening the nuts.
Follow the same procedure when installing the chicken door. In this case, you should also use the
number 6 screws, number 4 nuts and the small hinges.
If you wish to install an automatic chicken flap, this step is not necessary.
1
2
2
3
4
5
Mount the catch hook to keep the chicken flap open by screwing the hooks into the holes provided.
Hook on wall side Eyelet on door side
6. Mount the supports for the manure panel
Screws: 3, 9, 13
From the outside, drive the number 9 screw into the hole to the left of the chicken door. Place the
number 13 sleeve and the number 3 nut inside and tighten the nut.
Follow the same procedure with the left wall side (also from the outside).
Follow the same procedure with the rear wall side (also from the outside. The outer side is the side
on which there is no long milled groove).
1
2
6
Mounted state
3
81738=BA_Mobile_Coop_Holz_0622