Installation instructions
3.
Assembling the cabin
ATTENTION!
Observe the floor plan on page 8 and the illustrations starting
on page 13.
3.1. Assembling the base frame
With a hammer, carefully drive in the plastic dovetail keys on both corners of the
base frame until they are flush with the groove of the element.
Also screw the corners in place as shown.
A always designates the visible side, and appears on the top side of
the wall elements.
3.2. Installing wall elements
Start by installing the wall elements on the rear corners. The corner posts are
connected to the wall elements using Multiclips. Insert the corner post from above
down onto the wall elements. When doing so, make sure that the "Multiclips" are
aligned correctly. The corner post must be flush with the wall elements.
Installing the salt stone wall elements involves connecting them with the tongue
and groove and screwing them together. Make sure the ventilation element is
correctly positioned.
Install the salt wall lighting.
Now move the sauna to its final position and check the right angles (see tip on
page 4).
Install the side wall elements. Make sure the electronic element is correctly
positioned.
Install the posts for glass using the "Multiclips".
3.3. Assembling the glass elements
Place the U-shaped aluminium profile flush onto the glass element, and insert
the glass element into the groove provided on the wall element for this purpose.
Mount the strips above the window and the door, and screw them diagonally to
the corner post or the wall element.
p. 9/10
EN