Installation; Set-Up Instruction In Winter - Bestway Lay-Z-Spa Havanna AirJet Bedienungsanleitung

INSTALLATION

SET-UP
INSTRUCTION
IN WINTER
It is important to follow these suggestions if you are setting up the spa during the winter period. This will
prevent damage to the PVC material and extend the life of your product drastically.
• If the ambient temperature is below 10°C(50°F), we suggest keeping the package indoor where the
temperature is above 15°C(59°F) for at least 2h before inflation. This will make the spa liner more
flexible and easier to set up.
• Open the package in the same room where the temperature is above 15°C(59°F), and inflate the spa
using the spa heater.
• Position the spa liner outdoor in the desired position, connect the spa heater and fill with water.
Important: The water temperature used to fill the spa must be above 6°C(42.8°F), otherwise when
you begin to operate with the spa heater, the E03 alarm will appear.
Important: If the Freeze Shield™ system isn't working, alarms will pop up on the spa. Be sure to check
the status of your spa if the outdoor temperature is below 6°C(42.8°F). In case of a long-term absence
from home when there is a risk of temperatures falling below 6°C(42.8°F), we strongly suggest
disassembling the spa and storing it following the storage procedure. When you assemble the spa, the
automatic warm function will turn on. In this condition, the spa can be used when the temperature is
lower than 6°C(42.8°F).
< 10°C(50°F)
> 15°C(59°F)
15
> 15°C(59°F)