Configuration Via The Homematic Ip Wall Thermostat - eQ-3 HomeMatic IP HmIP-FAL230-C10 Installations- Und Bedienungsanleitung

Configuration via the Homematic IP Wall Thermostat

• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the LED lights up
green. The device is now ready for use.
• If the LED lights up red, please try again.
• Select the desired solution for your device.
• In the app, give the device a name and allocate
it to a room.
7 Configuration via the Homematic
IP Wall Thermostat
The Homematic IP Floor Heating Controller can
be configured via the Homematic IP Wall Ther-
mostat (HmIP-WTH-2), via the Homematic IP Ac-
cess Point together with the smartphone app or
via the WebUI of the Homematic Central Control
Unit CCU2.
To configure the Floor Heating Controller using the wall
thermostat, please proceed as follows:
• Press and hold down the control wheel of the
wall thermostat to open the configuration menu.
• Select the
wheel and confirm by pressing the control wheel
62
symbol by turning the control