Pairing With A Homematic Ip Wall Thermostat - eQ-3 HomeMatic IP HmIP-FAL230-C10 Installations- Und Bedienungsanleitung

Start-up
you must teach it in first.
You can either pair the Floor Heating Controller directly
with other Homematic IP devices (e.g. the wall thermostat
or the Multi IO Box) or teach it in to the Homematic IP
Access Point. After pairing, the device is configured at the
wall thermostat. After teaching-in to the Access Point, the
device is configured via the Homematic IP app.
6.4.1

Pairing with a Homematic IP Wall Thermostat

Please make sure you maintain a distance of at
least 50 cm between the devices.
You can cancel the pairing procedure by briefly
pressing the system button (A) again. This will be
indicated by the device LED (A)lighting red.
If no pairing operations are carried out, pairing
mode is exited automatically after 3 seconds.
If you want to pair the Floor Heating Controller with a
Homematic IP Wall Thermostat, the pairing mode of both
devices has to be activated first. To do this, proceed as
follows:
• Select the channel for pairing a device by press-
ing the select button (B) briefly (see fig. 7). Press
once for channel 1, twice for channel 2 etc. The
channel LED lights permanently for the corre-
58