Overload Protection; Overheat Protection - Makita DVC867L Betriebsanleitung

To remove the battery cartridge, slide it from the tool while sliding the
button in front of the cartridge.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not, it
may accidentally fall out of the cleaner, causing injury
to you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
NOTE: The cleaner does not work with only one battery cartridge.
Indicating the remaining battery capacity
Only for battery cartridges with the indicator ► Fig.4:
Indicator lamps 2. Check button
Press the check button on the battery cartridge to indicate the remaining
battery capacity. The indicator lamps light up for a few seconds.
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from the actual capacity.
Indicating the remaining battery capacity
► Fig.5:
1. Battery indicator 2. Check button
► Fig.6
Press the check button to indicate the remaining battery capacities. The
battery indicators correspond to each battery.
Remaining
capacity
Blinking
75 % to 100%
50 % to 75%
25 % to 50%
0 % to 25%
Charge the
battery.
The battery
may have
malfunctioned.
16 ENGLISH
On
1.
NOTE: During the cleaner turned on
with the stand-by switch set to
"AUTO", the battery indicator does
not work.
Tool / battery protection
system
The tool is equipped with a
tool/battery protection system. This
system automatically cuts off power
to the motor to extend tool and
battery life. The tool will automatically
stop during operation if the tool or
battery is placed under one of the
following conditions:

Overload protection

When the tool is operated in a
manner that causes it to draw an
abnormally high current, the tool
automatically stops without any
indication. In this situation, turn the
tool off and stop the application that
caused the tool to become
overloaded. Then turn the tool on to
restart.

Overheat protection

When the tool is overheated, the tool
stops automatically, and the battery
indicator blinks about 60 seconds. In
this situation, let the tool cool down
before turning the tool on again.
Battery indicator status
Off
Blinking
On
Rem
b
ca
50 %
20 %
0 %
Cha
b
Blinking