Care And Cleaning - Electrolux KFIA19R Benutzerinformation

30 www.electrolux.com
The hoods light works
independently to other hood
functions. To illuminate the
cooking surface press the
light button
To turn off the appliance press the first
speed button
3.2 Hob²Hood function
It is an automatic function which
connects the hob with a hood. Both the
hob and the hood have an infrared signal
communicator. Speed of the fan is
defined automatically on basis of mode
setting and temperature of the hottest
cookware on the hob. You can also
operate the fan using the hob manually.
The function can be activated from panel
of the hob.
For more information how to
use the function refer to the
hob user manual.
3.3 Filter notification
Filter alarm reminds to change or clean
the charcoal filter and clean the grease

4. CARE AND CLEANING

4.1 Notes on cleaning
Cleaning
Agents
Keep the hood
clean
.
again.
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water
and a mild detergent.
After cooking some parts of appliance can get hot. To avoid stains
appliance must be cooled down and dried with clean cloth or paper
towels.
Clean stains with a mild detergent.
Clean the appliance and grease filters each month. Clean the inte‐
rior and grease filters carefully from fat. Fat accumulation or other
residue may cause fire.
Follow the instructions for cleaning the accessories when filter noti‐
fication is on. Refer to Filter notification in daily use chapter.
Grease filters can be washed in a dishwasher.
The dishwasher must be set to a low temperature and a short cy‐
cle. The grease filter may discolour, it has no influence on the per‐
formance of the appliance.
filter. The filter indicator
for 30 seconds if the grease filter must
be cleaned. The filter indicator
for 30 seconds if the charcoal filter must
be replaced or cleaned.
Refer to cleaning the grease
filter in care and cleaning
chapter.
Refer to cleaning the
charcoal filter or replacing
the charcoal filter in care and
cleaning chapter.
To reset the function press the button
for 3 seconds.
To activate or deactivate function:
1. To activate function press the button
for 3 seconds.
If the function is activated, the indicator
flashes two times.
2. To deactivate function press the
button for 3 seconds.
If the function is deactivated, the
indicator flashes ones.
is turned on
flashes