Care And Cleaning - Electrolux LFD619Y Benutzerinformation

The hoods light works independently to
other hood functions. To illuminate the
cooking surface touch the light symbol
.
To turn off the appliance press the
again.
6.3 Activating Maximum Motor
Speed
When you press the button
Motor Speed starts to operate for 8 minutes.
After that time, the appliance returns to its
previous speed settings.
When the function is turned on, additional
touch on the button
any effects.
6.4 Filter notification
Filter alarm reminds to change or clean the
charcoal filter and clean the grease filter. The
filter indicator is turned on for 30 seconds
if the grease filter must be cleaned. The filter

7. CARE AND CLEANING

7.1 Notes on cleaning
Cleaning Agents
Keep the hood
clean
symbol
, the Maximum
does not have
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water and a mild detergent.
After cooking some parts of appliance can get hot. To avoid stains appliance must be
cooled down and dried with clean cloth or paper towels.
Clean stains with a mild detergent.
Clean the appliance and grease filters each month. Clean the interior and grease filters
carefully from fat. Fat accumulation or other residue may cause fire.
Follow the instructions for cleaning the accessories when filter notification is on. Refer to
Filter notification in daily use chapter.
Grease filters can be washed in a dishwasher.
The dishwasher must be set to a low temperature and a short cycle. The grease filter may
discolour, it has no influence on the performance of the appliance.
indicator flashes for 30 seconds if the
charcoal filter must be replaced or cleaned.
Refer to cleaning the grease filter in care
and cleaning chapter.
Refer to cleaning the charcoal filter or
replacing the charcoal filter in care and
cleaning chapter.
To reset the function touch
To activate or deactivate function (only for
charcoal filter):
1. Switch on the control panel.
2. Make sure that the icons are turned
white.
3. To activate function touch
seconds.
If the function is activated, the filter icon
flashes five times.
4. To deactivate function touch
seconds.
If the function is deactivated, the filter icon
flashes three times.
64
for 3 seconds.
for 3
for 3