capital sports Evo Pro Bedienungsanleitung Seite 44

EN
4
Attach the handles (4&5) to the support tube (15) with screws (9) and
washers (10). Connect the sensor as shown in figure 4 and then install the
computer (1) with a bolt (2) in the support tube (15). Before training, make
sure that all bolts and nuts are properly tightened and fastened.
Note: The end cap, which is attached to the front support tube, is movable,
allowing you to move the unit. The end cap on the rear support tube can be
adjusted in parallel.
44