Cleaning And Disinfection - neno PERFETTO Bedienungsanleitung

4. Ba ery Status (F) - The ba ery icon shows the ba ery charge status. Connect the device to charge when the
ba ery is low.
5. Device opera on me (J) - This indicator shows how many minutes have passed since the breast pump was
turned on. The device will automa cally turn off a er 30 minutes.
6. Suc on Level (I) - Shows the currently selected suc on level.

5. CLEANING AND DISINFECTION

Cleaning and sani zing are two different things. They need to be done separately, to protect your
child and to ensure proper func oning of the breast pump.
Cleaning – cleaning the surface and ge ng rid of stains and dirt.
Sani zing – ge ng rid of the bacteria and viruses that can be present on the surface of the device.
Before first use
A er every use
Once a day
NOTE: The pumping device, charging cable and charging adapter must not be washed or sani zed in water.
NOTE:
- Separate and wash all parts of the device that come into contact with milk immediately a er using the
device. Thanks to this, you will remove the sediment from the milk and prevent the growth of bacteria.
- Use only potable tap water for cleaning. Use bo led water if your tap water does not meet this requirement.
- When cleaning valves, do not use brushes. Be careful not to pierce the valve through.
- Disassemble, wash and rinse all parts of the breast pump that come into contact with the milk, except the
pumping device.
- Use a mild dishwashing liquid or soap when washing the breast pump parts.
See - Figure 3 on page 2
1. Washing (before first use and a er use - in the sink):
a. Rinse all disconnected parts (that have come into contact with breast and milk)
in cold water to rinse out any milk residue and sediment.
b. Soak in warm soapy water for 5 minutes, then wash and rinse.
c. Let the elements dry naturally. Keep the dry parts of the device cool
and a dry place when not in use.
6. ASSEMBLY OF THE BREAST PUMP
1. Wash your hands thoroughly with soap and water before touching the breast pump and breast.
2. Connect the diaphragm and the pumping device to the coupling.
3. Connect the funnel to the connec on.
4. Place the valve in the joint.
5. Screw the bo le un l it locks into place by turning it clockwise un l it stops.
Advice:
a. Before each use, check if the parts of the breast pump are not damaged. If necessary replace damaged parts
with new ones.
b. Always check the cleanliness of components before using the device.
c. To avoid damaging the breast pump, make sure all its parts are dry before ge ng started
Breast pump elements
(connector, suc on bowl,
Breast shield
suc on cap)
Clean and sani ze
Clean
Sani ze
9
Clean and sani ze
Clean
Sani ze
Bo le and teat set
Clean and sani ze
Clean
Sani ze