Long-Term Storage - neno PERFETTO Bedienungsanleitung

7. C HARGING THE BREAST PUMP
Before the first use, charge the breast pump for 2 hours by connec ng it to the power supply using the USB
cable. The ba ery icon on the display will be full when charging is complete.
Full blinking ba ery - low ba ery, connect the device for charging.
Incomplete blinking ba ery - ba ery connected to charging, current charging status the ba ery.
Full Ba ery - Ba ery fully charged
The breast pump can be used while the device is connected to charging. Your device's ba ery will be charged
when you connect it to power. The device ba ery will not be charged while the pumping device is turned on.
Fully charge the ba ery of the breast pump before storing it if you intend not to use the device for a long period
of me. Charge the device ba ery before it is completely drained. This extends the ba ery life. If the breast
pump has been stored in a hot place, the ba ery of the device may not work at first. Allow the breast pump to
cool down for an hour before using it.
8. USING A BREAST PUMP
See - Figure 1 on page 2
1. Place the funnel over the breast with the nipple inside the drainage channel.
2. Press the funnel and the connec on of the breast pump to your breast using your thumb and index finger.
Support your breast with your hand.
3. Turn on the breast pump by pressing the power bu on and select the opera ng mode that suits you.
4. Press the power bu on to turn off the breast pump a er use and place the lid on the funnel to protect the
device from dust.
a. The breast pump starts to work in s mula on mode. Set a convenient suc on level for you using the +/-
bu ons. S mula on Mode - Fast pumping that mimics your baby's natural suckling of milk from the breast to
s mulate milk flow.
b. A er 2 minutes, the breast pump will automa cally enter the deep pumping mode. Adjust the suc on level
using the +/- bu ons to find the highest suc on level that is comfortable for you. If milk starts to flow from your
breast within two minutes, press the Mode Shi Bu on to manually enter feeding mode.
Deep Pumping Mode - Slower pumping that draws milk gently and efficiently from your breasts.
c. In feeding mode, increase the suc on power un l you feel a slight discomfort (not pain) and reduce the suc on
power by one degree.
Mixed Mode - mimics the baby's suckling pa ern by programming the speed and power of the suc on. It can be
used a er pumping to help empty the breast and increase lacta on.
9. MILK PREPARATION
1. Do not defrost frozen milk in a microwave oven or in boiling water. It may burn the baby's mouth.
2. Thaw the milk in the refrigerator overnight. Do not re-freeze thawed milk once. You can defrost the milk
quickly by keeping it under running water at a maximum temperature of 37 ° C.
3. Place the closed bo le / bag in a bowl of warm water for 20 minutes to bring the milk to body temperature.
4. Do not add freshly drained milk to previously frozen milk if the amount of fresh milk exceeds the amount of
previously frozen milk.
a. It is recommended that you breas eed your baby before you start bo le-feeding your baby.
b. Always check the bo le, nipple and other components before and a er each feed. If the teat is damaged, stop
using it immediately.
c. To avoid the risk of suffoca on of the baby, test the strength of the nipple by gently pulling on the protruding
part.
d. Do not try to enlarge the opening in the nipple.
e. Babies should not be bo le-fed without adult supervision.
f. The bo le teat should not be used as a soother to soothe your baby.

10. LONG-TERM STORAGE

The breast pump has a built-in ba ery. To protect against damage, the device goes into storage mode a er a
long period of inac vity. To disable storage mode, connect the device to power and charge it for 2 hours.
Before you put the breast pump down for an extended period of me, make sure that:
a. All parts of the breast pump are clean.
b. You have cleaned the pumping equipment.
c. Device ba ery is fully charged.
10