Installation Of Accessories; Installing/ Removing The Antenna; Installing The Belt Clip; Installing The Battery Pack - Retevis RB627B Bedienungsanleitung

c. Keep it away from hot places and direct sunlight.
» Do not short circuit the battery terminals.
» Never attempt to remove the casing from the battery pack.
» Never store the battery in unsafe surroundings, as a short may cause an explosion.
» Do not put the battery in a hot environment or throw it into a fire, as it may cause an explosion.

3. INSTALLATION OF ACCESSORIES

Before the radio is ready for use we need to attach the battery pack, as well as charge the
battery.

3.1 Installing/ Removing the Antenna

a. Installing the Antenna: Screw the antenna into the connector on the top of the transceiver by
holding the antenna at its base and turning it clockwise until secure.
b. Removing the Antenna: Turn the antenna counter-clockwise to remove it.
3.2 Installing the belt clipa.
a. To install the BELT CLIP, slide the clip down into the slot on the back of the radio until the
BELT CLIP LATCH clicks.
b. To remove the BELT CLIP, press the LOCK TAB down, and then gently pull the belt clip up
toward the top of the radio.

3.3 Installing the battery pack

Before attaching or removing the battery make sure your radio is turned off by turning the
power/volume knob all the way counter-clockwise.
To install the battery pack:
1. With the back of the radio facing you, insert the bottom part of the Li-ion battery pack to the
bottom of the radio.
2. Push down the Li-ion battery pack into the radio until the Battery Lock Tab locks into place.
To remove the battery pack:
1. Press the Battery Lock Tab downward until the Li-ion battery pack unlocks from the radio.
2. Pull the Li-ion battery pack away from the radio.
3.4 Installing the Additional Speaker/Microphone (Optional)
Pry open the rubber MIC-Headset jack cover and then insert the Speaker / Microphone plug into
the double jack.

4. RADIO OVERVIEW

4.1 Buttons and controls of the radio

1. Antenna
2. LED Flashlight
3. Power Switch/ Volume control
4. Led: transmission (red) / reception (green)
5.[LAMP]: Press the key once to turn on the flashlight, Press and hold the key again to flash the
flashlight, and press the hand again to turn off the flashlight; Press and hold the key to turn on
the audible and visual alarm function
6. [PTT]:Transmit key, hold the key to speak, release the key after speaking, and receive
incoming calls;
7. FM: Press to turn on the radio function, and press again to turn off the radio function;
8. [SCAN ]: Initiate a ring tone call; Press and hold this key to activate the scan function and
enter the scan.
9. [MONI]: Press and hold to enter MONITOR mode.
3