Fault Messages - Alde 3010 613 Montageanleitung Und Bedienungsanleitung

11. Fault messages

+22°C
Gas failure
12. Emergency start
• Disconnect the 12V cable and the cable to the panel on the boiler.
• Connect a cable between 2 and 9 in the connector on the boiler.
• Reconnect 12V to the boiler
Now the boiler starts with gas and 1kW. Adjustment of the room temperature
is not working. Constant pump operation is set.
Fuse 3,15 A (-)
12 V DC
If an error occurs in the system, the display will show the reason.
This is only displayed when the panel is on standby.
Battery too low: If the vehicle, boat or building has a battery voltage of
less than 10.5V, the boiler stops. It is automatically reset when the voltage
reaches 11V.
Fan failure: Faulty fan speed. In order to reset, disconnect 12V from the
boiler and reconnect (automatic reset after 5 minutes).
Gas failure: Gas finished. Reset by switching off and restarting the boiler
in accordance with item 1.
Overheat red fail: Overheating protection (red cable) triggered. To reset,
disconnect 12V from the boiler and reconnect.
Overheat blue fail: Overheating protection (blue cable) triggered. To
reset, disconnect 12V from the boiler and reconnect.
Window open: Window open, the boiler stops for gas. Gas operation in
the boiler starts again when the window is closed. The electrical opera-
tion remains in function. Check the vehicle, boat or building manual to see
whether this function is installed.
Connection failure: There is a connection fault between boiler and panel.
To reset, disconnect 12V from the boiler and reconnect.
Connection fail ext: Communication error between Alde's panel and
external panel.
Panel failure 1: Panel fault.
Panel failure 2: Panel fault.
2
Control
Fuse 3,15 A (+)
panel
9
12 V 230 V
pump
pump
Art. No. 3010 218
17