Alde 3010 613 Montageanleitung Und Bedienungsanleitung Seite 15

9. Automatic anti-bacterial mode
(legionella)
At 02.00 at night (if the clock is set) the
boiler starts and works according to "Hot
water boost" (see section 5). This is in
order to reduce the risk of legionella. The
function is deactivated in the factory set-
ting.
10. Offset (temperature adjustment)
Using this function, you can calibrate the
temperature on the panel if you notice that
the temperature (the stabilised room tem-
perature) is not the same as the tempera-
ture shown on the panel. This also applies
to outdoor temperature.
11. Button sound
With this function, you can activate or
deactivate the button sound.
The button sound is activated in the factory
setting.
12. Screen Brightness
Brightness: The brightness of the display
(working mode) can be adjusted from 1 to
10. Factory setting is 5.
Standby brightness:
Off: Used to turn the display's backlight-
ing off so that the display is turned off
(becomes dark) in standby mode (the LED
is still active).
On: Used to activate the backlighting in the
display (low lighting) in standby mode (the
LED is still active). Factory setting is On.
13. Language
Lan
This function is used to reset the screen
between different languages. Available
languages are: English, French and Ger-
man. On the other hand, the service menu
is only in English (see section 10.1).
14. Tools / Key
Under Tools / Key you can lock or unlock
access to the tool menu.
Ext
15. *External start
This function is used when starting the
boiler from the outside, for example, with
GSM. When external start has been acti-
vated, the control panel's On/Off button
must be switched off (see the assembly
setting manual for external start). NOTE!
To use this function, an external start
installation is required (see the manual
for the vehicle, boat or building).
*230 V
This function is used in connection with
starting the boiler when connection of
230 V to vehicle takes place from outside.
When the 230 V function has been activa-
ted the control panel's on/off button must
be turned off, but 12 V must be connected
(the vehicle's main switch is on). Before
turning off the control panel with the on-/
off button set the parameters/functions that
you want the boiler to have when it starts
(230 V is connected).
Amp
16. *Load monitor
This function is used to prevent the 230V
fuses being overloaded. If the total power
consumption of the vehicle, boat or build-
ing exceeds the set value, the boiler's
power will be automatically reduced. On
account of voltage variations and toler-
ances, different setting levels can be
selected (for example, for 6A fuse, one
can choose 6 or 7 Amp setting). If the fuse
does not hold, choose a lower set value.
The function is deactivated in the factory
setting. NOTE! The load monitor has to
be installed for the function to be used
(see the manual for the vehicle, boat or
building).
15