H. Moser & Cie STREAMLINER CENTRE SECONDS AUTOMATIC 6900 Bedienungsanleitung Seite 19

Winding position
In position 0 – the winding position – the STREAMLINER
CENTRE SECONDS AUTOMATIC can be wound by hand using
the crown. To wind your watch, the crown must be turned
clockwise to tighten the winding spring.
The watch is automatically wound by the rotor, which works
with the movement of your wrist during wear. However, this
feature is dependent on how long the watch is worn and
can vary depending on the extent of your arm movements.
The time setting position
To reach the position for setting the time, pull the crown out
from the normal position. When the crown is engaged in
position 1, you can set the minute hand by turning the
crown in either direction. This will move the hour hand that
is linked to the minute hand at the same time. To restart the
movement, push the crown back into position 0.
19