Light Bulb Replacement; Power Supply Connection; Cleaning And Maintenance; Carbon Filter - GLOBALO Laizeno 60 Gebrauchs- Und Montageanleitung

LIGHT BULB REPLACEMENT

ATTENTION!
• DISCONNECT THE HOOD'S POWER SUPPLY PRIOR TO REPLACING THE BULBS.
• DO NOT TOUCH THE LIGHT BULBS WHEN HOT.
• TAKE CARE NOT TO TOUCH THE INSTALLED LIGHT BULB BY HAND.
BULB INSTALLATION
BULB REMOVAL
THE USER IS ALLOWED
TO CHANGE THE BULBS
HIMSELF

POWER SUPPLY CONNECTION

The supply voltage must correspond to the voltage indicated on the identification plate placed
inside the hood. If the hood is equipped with a plug, insert it in an accessible socket compliant
with the applicable regulations. If the hood is not equipped with a plug, the installation should be
carried out by a certified specialist (e.g. an electrician).

CLEANING AND MAINTENANCE

Before performing any maintenance operations, unplug the device from the socket. Use mild de-
tergents for cleaning. Do not use abrasive cleaning products. The hood should be cleaned at least
once a month or every 35 hours of operation. DO NOT USE ALCOHOL-BASED CLEANING AGENTS.
Inox parts should be cleaned with special product (e.g. BERNER).

CARBON FILTER

The hood may be equipped with a carbon filter. Use the filter only when the hood is not connected
to the ventilation duct. Place the filter on the turbine housing as shown in Fig. 14. The filter should
be replaced every 3-6 months.
EN
Fig. 13
GU10
31