LIGHT BULB REPLACEMENT
ATTENTION!
• DISCONNECT THE HOOD'S POWER SUPPLY PRIOR TO REPLACING THE BULBS.
• DO NOT TOUCH THE LIGHT BULBS WHEN HOT.
• TAKE CARE NOT TO TOUCH THE INSTALLED LIGHT BULB BY HAND.
BULB INSTALLATION
BULB REMOVAL
THE USER IS ALLOWED
TO CHANGE THE BULBS
HIMSELF
POWER SUPPLY CONNECTION
The supply voltage must correspond to the voltage indicated on the identification plate placed
inside the hood. If the hood is equipped with a plug, insert it in an accessible socket compliant
with the applicable regulations, as it shows is in Fig. 10. If the hood is not equipped with a plug,
the installation should be carried out by a certified specialist (e.g. an electrician).
CLEANING AND MAINTENANCE
Before performing any maintenance operations, unplug the device from the socket. Use mild de-
tergents for cleaning. Do not use abrasive cleaning products. The hood should be cleaned at least
once a month or every 35 hours of operation. DO NOT USE ALCOHOL-BASED CLEANING AGENTS.
Inox parts should be cleaned with special product (e.g. BERNER).
GU10
EN
GU10
Fig. 13
31