Renkforce 1034064 Bedienungsanleitung Seite 18

The submersion pressure pump pressure must not work against the closed pressure side for
more than 5 minutes to prevent damage. The water present in the submersion pressure pump
will heat up even during these 5 minutes. When the pressure side is opened, hot water will
escape; danger of scalding/injury!
• Do not put the product with the intake openings directly into sludgy, sandy or stony ground,
e.g. at the bottom of a garden pond. Use, e.g., a stone plate as a basis. Otherwise, the intake
openings may be fully or partially blocked even after a short time!
Sand, small stones or other hard objects in the conveyed liquid will otherwise lead to increased
wear and reduction of performance of the submersion pressure pump.
• Check the entire product for damage before any commissioning, e.g. damage to the casing and
mains cable/plug.
If you find any damage, the product must not be used.
If the product is already connected to the mains voltage, first switch off all contacts of the
associated mains socket by deactivating the circuit breaker or turning out fuse; then switch off
the associated FI protection switch.
Only now unplug the submersion pressure pump mains plug from the mains socket. Do not
operate the product anymore afterwards, but take it to a specialist workshop.
Never perform any repairs on your own. Always leave them to a specialist!
• If you have reason to believe that the submersion pressure pump can no longer be opera-
ted safely, disconnect it immediately and make sure it is not unintentionally operated; pull the
mains plug from the socket. It can be assumed that safe operation is no longer possible if:
- the submersion pressure pump or connection lines show visible damage
- the submersion pressure pump no longer works
- the submersion pressure pump has been transported or stored under difficult circumstan-
ces
- if it was subjected to heavy stress during transport.
• Always disconnect the mains plug from the mains socket when you are no longer using the
product, for troubleshooting or for cleaning/maintenance.
• Never pull the mains plug from the mains socket by pulling the cable. Always pull the mains
plug from the mains socket by the lateral grip areas.
Never touch the mains plug with wet or damp hands; danger to life from electric shock!
• Only transport the product at the carry handle but never at the mains cable.
• If the product is brought from a cold into a warm room (e.g. in transport), it is possible that
condensation develops. This causes danger to life from electric shock!
Therefore, you should allow the product to warm up to room/ambience temperature before
using it or connecting it to the mains voltage. This may take several hours.
18