Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Attach the black (-) clamp to the (-)
battery terminal.
Note:
The black (-) clamp can also be connec-
ted to the vehicle chassis (Please refer
to the auto maker's instructions!). Be
sure both clamps have good contact
and are securely seated.
Warning!
Risk of fire and electric shock! If
possible, connect the charger to the
230 V power socket without extension
cable. In exceptions, use the shortest
possible undamaged and unrolled 230 V
extension cable.
4. Plug the charger plug into a 230V
power socket.
With the charger correctly connected,
the charger will start, showing the
start-up display (standby mode). In this
mode the charger will automatically
reset to the default settings.
If the battery is recognised to be
defective or connected with the poles
reversed, the error indicator (Er 1) will
light up. In this case, unplug the charger
and check the battery and the correct
connection (also see "Troubleshooting").
Note:
A battery is recognised to be defective
if the battery voltage is below 3.0 V (6 V
battery or 12 V battery). Have the bat-
tery checked by a speciality repair shop.
Start charging
1. Repeatedly press the „Mode" (2)
button to select the desired charging
mode 6 V, 12 V or 24 V.
2. The charging process will start
automatically.
Note:
In temperatures below 0 °C, also select
mode.
If an incorrect charging mode was se-
lected, the error code (Er 1) will appear.
In this case unplug the charger, wait
briefly, and plug in again.
Note:
•
During the charging process the
blocks inside the battery symbol will
flash based on the charging status.
•
With the battery fully charged, all
blocks inside the battery symbol will
light up.
•
In addition, the display will show the
current battery voltage.
•
Once the battery is fully charged, the
charger will switch to trickle charge to
maintain the charging status and pro-
tect the battery from overcharging.
Display light
Press the "Mode" button (2).
The display light will automatically
switch off after approx. 30 seconds
whilst charging. Press the Mode button
at any time to light the display for
approx. 30 seconds.
Power Supply Mode
1. Connect the charger as described
under "Connecting The Device".
2. To enable Power Supply mode,
hold the "Mode" button (2) for 5
seconds. The
the display.
The charger will keep powering elec-
tronic systems in your vehicle, even if
the battery is disconnected from the
vehicle.
3. To exit Power Supply mode, hold the
"Mode" button (2) for 5 seconds.
Complete charging and dis-
connect charger
1. Always first unplug the power plug
from the 230V alternating current
socket.
2. Disconnect the black (-) clamp from
the (-) battery terminal or the vehicle
chassis.
3. Disconnect the red (+) clamp from
the (+) battery terminal.
Battery Charger BC240, BC260, BC280
EN
symbol appears in
17
Werbung
Inhaltsverzeichnis
Fehlerbehebung
