Streifeneder KINEGEN.air Gebrauchsanweisung Seite 33

Install the new brake bushing and press the knee axis into the bushing. Then
screw the allen head screw in. Apply superglue 118P29 on the screw for
securing.
Reassemble in the reverse order.
Attention!
Loctite can negatively effect the function of the knee joint,
therefore: Do not use Loctite!
Push out the knee axis and remove the
brake bushing.
The position of the brake bushing is
secured by the allen head screw and
the borehole in the brake bushing.
Apply superglue 118P29 on the axis
screws and tighten them with a
calibrated torque wrench 173P11
(8 Nm).
33/40