Concept LO 706-Serie Bedienungsanleitung Seite 25

EN
Fruits with hard seeds and peel, peel and remove seeds first. Fruits like: Strawberries , Raspberries, Blueber-
ries, you can insert a whole.
Do not use nuts or ice cubes
Chille desserts
1. Place the appliance on a stable surface.
2. Prepare a bowl for dessert under the drain in front of the body of
the appliance.
3. Place the processing bowl on the upper body of the appliance.
4. Put the stainer for the preparation of chilled desserts (marked Ice
Cream Maker) into container.
5. Insert a auger.
6. Assemble the top cover and secure it by rotate.
7. Mix the recommended raw materials (frozen fruit) with cottage
cheese of yoghurt In the prepared bowl.
8. Switch ON the appliance. Speed 1 is normal. Speed 2 is the
reverse.
9. Put the mix to the processing bowl slowly.
WARNING !
Only load properly washed and remove-seed fruit. If the noise level becomes considerably higher, or there
are stronger vibrations, clean the unit immediately!
Use frozen fruits such as: strawberries, raspberries, blueberries, bananas
Do not seeded fruit, nuts or ice cubes.
WASH PROGRAM
To facilitate cleaning, we recommend that after the completion of the process of juicing
conclude Anti Drip cap, fill the container to the mark Wash Program with water up and
about 3 minutes appliance switch on. Then open the cap and let the water drain into the
prepared pan. If necessary, repeat the procedure.
More in video on www.my-concept.cz
program
Note: If the container is not a guideline, pour into a container of about 400 ml water.
Missing guideline is not a reason for complaint.
48
CLEANING AND MAINTENANCE
Wash the removable parts in warm water. Use the supplied brush.
Never clean the unit under running water, do not rinse it, and do not submerge it in water!
1. Open the upper cover.
3. Remove and clean the pulp container.
TROUBLESHOOTING
Problem
Motor does not run.
Motor is noisy.
ACCESSORIES
Ord. No.: 42391469
LO 706x LO 706x
Cause
The mains outlet is not live.
appliance.
Check assembly of the unit.
Refer the unit to an authorized service center
Check the assembly of the unit.
Disconnect the cable from the socket.
Release the upper lid, empty the pulp
EN
Solution
49