Troubleshooting - Stihl BGA 85 Gebrauchsanleitung

English

Troubleshooting

Always remove the battery before carrying out any work on the power tool.
Condition
Machine does not start when switched on
44
Cause
No electrical contact between power tool
and battery
Battery flat
(1 light emitting diode on battery flashes
green)
Battery too hot / too cold
(1 light emitting diode on battery glows red)
Fault in battery
(4 light emitting diodes on battery flash red
Power tool too hot
(3 light emitting diodes on battery glow red)
Electromagnetic problem or fault in
machine
(3 light emitting diodes on battery flash red)
Moisture in power tool and/or battery
Remedy
Remove the battery, visually check con -
tacts and refit battery
Charge the battery
Allow battery to cool down / allow battery
to warm up slowly at temperature of
about 15°C - 20°C
Take the battery out of the power tool
and refit it. Switch on the machine – if the
LEDs continue to flash, the battery is
faulty and must be replaced.
Power tool is too hot – allow it to cool
down.
Take the battery out of the power tool
and refit it. Switch on the power tool – if
the light emitting diodes still flash, the
power tool is faulty and must be checked
1)
by a servicing dealer .
Allow power tool / battery to dry
BGA 85