Dantherm ACT-7 Bedienungsanleitung Seite 14

Display
14
1
Pos . Display
1 Current temperature
2 Defrost (active)
3 Air Condition (active)
4 Alarms (flashing):
• H = High pressure
• L = Low pressure
5 Tank full indicator
(flashing)
6 Fan speed
7 Overheat warning
ACT-7
22
c
HL
2 3 5
4
Fig. 7
Description
Measured sensor temperature.
The ACT 7 runs the defrost mode when needed and auto-
matically returns to cooling/fan only mode when finished.
The ACT 7 is in air condition mode.
The alarm has to be reset (see "Menu overview" on page
15) when the error has been rectified (find help for trou-
ble shooting on page 17).
The alarm resets itself and works as follows:
1. When the alarm appears the ACT 7 will continue to
work for the next 30 seconds.
2. If the condensate tank has not been emptied, the
pump continues to operate while the ACT 7 stops cool-
ing.
3. When the condensate tank is emptied, the alarm will
disappear and the ACT 7 will restart after a delay of
minimum one minute and maximum six minutes.
Displaying the fan speed adjusted by the fan speed dial.
Indoor temperature is too high (above 35 °C). The symbol
will disappear automatically, when the room temperature
drops below 35°C and the ACT 7 starts up again.
(see also "Trouble shooting" on page 17)
Operation: User interactions
7
6