Electrical Connection - Meec tools 015273 Bedienungsanleitung

CONNECTION OF OUTLET TUBE
IMPORTANT:
Risk of material damage. The outlet tube
should be installed so that it does not
transfer mechanical stress to the pump.
• All the screw unions should be sealed with
jointing tape. Any leakage will allow air to
penetrate the system, which reduces the
pumping capacity.
• Use teflon tape for metal threads and
normal jointing tape for plastic threads.
• All parts of the outlet tube should be
installed by qualified personnel.
WARNING!
Risk of personal injury. If components are
used that cannot withstand the pressure, or
if the installation is not carried out correctly,
the outlet tube can burst and spray out
water, which can cause personal injury and/
or material damage.
NOTE:
The product is not intended for transporting
drinking water, only to transport water for a
toilet or washing machine.

ELECTRICAL CONNECTION

WARNING!
Electrical safety! Do not expose the product
to rain, or use it in damp conditions.
Prerequisites
• The plug must be plugged into a correctly
installed and earthed power point.
• Check that the mains voltage corresponds
to the rated voltage on the type plate and
that the circuit is correctly fused.
• The product must always be connected to
a residual current device with a tripping
current of ≤ 30 mA when used for pools
and ponds.
• If the product is used outdoors, only use
an extension cord approved for outdoor
use. The product must not be put in water.
• If an extension cord is used the cross-
sectional area of the wires must be
dimensioned for the power supply to the
product. If an extension cord is used on a
reel, pull out the full length of cord.
HOW TO USE
FILLING THE PUMP HOUSING AND
SUCTION TUBE WITH WATER
IMPORTANT:
Risk of material damage. The product must
be filled with water each time it is connected
to a new installation and if the water has run
out or air has penetrated into the system.
Do not leave the product unattended when
running. Dry running can result in material
damage.
1. Remove the product from the packaging
and place it on a level, stable surface.
FIG. 2
2. Unscrew and remove the water filler plug
and its seal.
3. Connect the suction hose to the water inlet
and the outlet hose to the water outlet.
FIG. 3
4. Open the refill opening cap and fill with
water until it runs over.
FIG. 4
5. Replace the water filler plug and its seal
and tighten.
6. The suction tube can be filled with water
to shorten the suction time (only possible
if the tube has a non-return valve).
7. Open the tap on the suction tube so that
air can flow out during the suction time.
8. Plug in the plug and start the pump.
FIG. 5
EN
29