Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
When you operate the product outdoors, use
an extension cable that is applicable for outdoor
operation. This decreases the risk of electrical
shock.
•
Keep the connection to the extension cable dry and
off the ground.
•
Keep the extension cable away from heat, oil, sharp
edges or moving parts. A damaged cable increases
the risk of electrical shock.
•
Make sure that the extension cable is in good
condition and not damaged.
•
Do not use the extension cable while it is wound up.
This can cause the extension cable to become too
hot.
•
Make sure that the extension cable is behind you
and the product when you use the product. This
prevents damage to the extension cable.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
•
Do not use a product with defective safety devices.
•
Do a check of the safety devices regularly. If
the safety devices are defective, speak to your
Husqvarna service agent.
To do a check of the start/stop and function selection
switch
1. Set the start/stop and function selection switch to
"0".
2. Connect the product to the power supply.
3. Set the start/stop and function selection switch to
"1". The drive motor starts.
4. Set the start/stop and function selection switch to
"2". The drive motor is on and the vibration motor
starts.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Read the operator's manual for the dust extractor
carefully and make sure that you understand the
instructions.
3. Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
8
Read the warning
Operation
Before you operate the
5. Set the start/stop and function selection switch to
"0".
6. Make sure that the drive motor and the vibration
motor stops.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
•
Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
•
Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
•
If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
•
Clean the product to remove dangerous material
before you do the maintenance.
•
Before you do the maintenance, stop the motor and
disconnect the power plug.
•
Do the maintenance of the product on stable level
ground.
•
Do not do modifications to the product. Modifications
that are not approved by the manufacturer can
cause serious injury or death.
•
Replace damaged, worn or broken parts.
•
Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
•
After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
•
Let an approved service agent do servicing on the
product regularly.
4. Do daily maintenance. Refer to
schedule on page 14 .
5. Make sure that the product is assembled correctly
and is not damaged.
6. Make sure that only approved persons are in the
work area.
7. Put the product on the work area. Make sure that the
transportation of the product to and in the work area
is done safely and correctly. Refer to
storage and disposal on page 20 .
8. Connect a dust extractor to the product. Refer to
connect a dust extractor on page 10 .
Read the warning
Maintenance
Transportation,
To
1804 - 001 - 06.05.2022
Werbung
Inhaltsverzeichnis
Fehlerbehebung
