Troubleshooting - Husqvarna BS 75 Bedienungsanweisung

To adjust a drive lever
1. Remove the nut and the screw.
2. Remove the drive lever.
Problem
The product does not
start.
The product is not
easy to hold on to.
The product is not
easy to move.
18

Troubleshooting

Cause
The extension cable is disconnected or dam-
aged.
Examine the frequency drive for error codes.
The emergency stop button is engaged.
The vibration damping units are worn or
damaged.
The lower motor bearing is defective.
The blade is blunt or not correctly installed.
There is a blockage at the wheel scraper
plates or the wheel scraper plates are dam-
aged.
There is a blockage at the wheels or the
wheels are damaged.
3. Turn the adjustment screw to the correct position.
4. Install the drive lever, the screw and the nut.
Solution
Connect the extension cable or if it is neces-
sary, replace the extension cable.
Make sure that the cable is replaced if it is
damaged.
Error codes on page 19 .
Refer to
Turn the emergency stop button on the con-
trol panel clockwise to disengage.
Replace the vibration damping units.
Speak to an approved Husqvarna service
agent.
Do a check of the blade and sharpen or re-
place it as necessary.
Clean and examine the wheel scraper plates.
Replace damaged parts.
Clean and examine the wheels. Replace
damaged parts.
1804 - 001 - 06.05.2022