General product maintenance
Clean the product.
Do a check of all safety devices.
Make sure that nuts and screws are tight.
Do a check of the electrical components,
the cables and the connections for wear and
damages.
Do a check of the hose connections. Do a
check of all hoses on the product for dam-
ages or leakage.
Make sure that the dust hoses are not dam-
aged and free of blockage.
Make sure that the dust collector is empty
and connected correctly.
Do a complete servicing and cleaning of the
product.
BMP 215: Make sure that the power plug and
extension cable are in good condition and
not damaged.
BMP 215Petrol: Make sure that there is no
oil or fuel leak.
To clean the product
•
Always clean all the equipment after use. Use a
vacuum cleaner.
•
Do not use a high-pressure washer to clean the
product.
•
Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
•
Clean the tool drum after operation on moist
surfaces.
To change the direction of rotation of
the motor BMP 215
1. Stop the motor. Refer to
32 .
2. Wait until the product is fully stopped.
3. Disconnect the power plug.
4. Turn the inverter switch in the mains plug to the
opposite position.
1819 - 002 - 07.04.2022
To stop the product on page
Daily
12h after service
X
X
*
*
*
*
*
*
*
Scarifying drum
Tools for the scarifying drum
There are different tools for the scarifying drums, Cutters
(A) and Milling cutters (B). The tools are applicable for
different surfaces.
A
B
Yearly
*
O
33